Adjustable Leveller
Adjustable Leveller
"The Leveller" is the perfect solution for levelling and adjusting all your projects such as posts, steps, decks and patios. They work perfectly on any type of post or leg. If you're building a new deck, step or patio, or retrofitting an old one, simply find centre of leg or post, drill a 1 1/4" hole, attach top of leveller to bottom of post or leg with 3 screws ( #8 up to 1/4"), thread in bottom of leveller and your installation is complete.
If you're building your deck, step or patio on concrete sidewalk blocks, footings or steel screw in piles don't worry if the footings aren't all quite level with each other. Simply install the leveller in the legs and level the joists or beams as you go. Later on when your deck, step, or patio, settles or heaves, (as they always eventually do) simply adjust the levellers and your project will be level again. If you need to attach the base to the footings or piles, use the holes provided as they are, drill them out for larger diameter fasteners or use GH The Leveller base plate (NEW ITEM).
Unlike other products used for this purpose, our levelling foot is installed inside the leg or post. This means the threads are protected from the elements. It can be installed at the base of post or between the post and joist. The Leveller is made from thick 1" grade 5 zinc coated steel for tremendous strength and corrosion resistance. We've tested it to 7000 pounds, but with an SAE proof load rating of 85000 psi, we know it will hold much more.
Castle Engineering LLP 145-1st Ave NE , Swift Current, Saskatchewan was retained to complete the load capacity analysis of GH The Leveller. The results were:
Analysis Design Capacities: Max Vertical Loading (at center of Leveller): 18,000 lbs (80kN)
Max Shear Eccentric Loading (at edge of disc): 1490 lbs (6.6kN)
Factored Shear Resistance,Vr: 62.7 kips (279kN)
CASTLE ENG. PROJ. # 18-1786
The Leveller has the added distinction of looking nice as well. So instead if trying to hide some adjustable contraption that really isn't that pleasing to look at, you can install the levellers where they are easy to access and adjust. They really do look like they belong!
The Leveller works perfect for levelling and adjusting many projects such as:
-wooden posts, steps, decks or patios
-Steel posts, steps, decks, or patios (weld in leg)
-Garden arbors
-Outdoor porch's
-Outside door frame supports (adjust that old door so it won't rub)
-Work bench's, tool stands (adjust your work bench or stand so it sits evenly on that uneven floor)
-Stair landings
-Garden Sheds
-Platforms, stages.
All you need to install The Leveller is a drill, 1 1/4" spade or auger drill bit (available at any hardware store), screws and screwdriver or drill driving bit.
You can easily adjust the levelling feet with a large wrench, pipe wrench or pliers. Another simple and easy way to adjust The Leveller is by using a pry bar, jack, or even a piece of 2 x 4 to pry up on leg or post and simply adjust the footing by hand by threading it in or out. It really is that simple!
NEW PRODUCT - The Leveller Base Plate. Slips over The Leveller to easily attach Leveller to base, yet allowing the ability to easily adjust.
NEW PRODUCT - The Leveller Base Plate. Slips over The Leveller to easily attach Leveller to base, yet allowing the ability to easily adjust.